Search

1.1 These requirements cover hardware for the support of conduit, tubing, and cable, such as HANGERS, STAPLES, STRAPS, and similar devices for installation in accordance with the National Electrical Code, NFPA 70, and the...

1.1 These requirements cover permanently installed devices, hereafter referred to as dimmers, that employ a dimming function intended for control of lighting loads of the magnetic ballast, transformer, electronic ballast...

1.1 * Scope This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of MEDICAL ELECTRICAL EQUIPMENT and MEDICAL ELECTRICAL SYSTEMS, hereafter referred to as ME EQUIPMENT and ME SYSTEMS. If a clause...

1.1 * Scope This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of MEDICAL ELECTRICAL EQUIPMENT and MEDICAL ELECTRICAL SYSTEMS, hereafter referred to as ME EQUIPMENT and ME SYSTEMS. If a clause...

Subclause 1.1 of IEC 60601-1:2005, Clause 1 is replaced by: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of a VENTILATOR in combination with its ACCESSORIES, hereafter referred to as ME...

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric commercial amusement machines and personal service machines, their rated voltage being not more than 250 V for...

1.1 Purpose This document provides a set of critical system of systems (SoS) considerations to be addressed at key points in the life cycle of the system of interest (SoI). This document refers to considerations that apply to...

This document applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of both FIXED and MOBILE X-RAY EQUIPMENT declared by the MANUFACTURER to be suitable for RADIOSCOPICALLY GUIDED INTERVENTIONAL PROCEDURES, hereafter referred...

This part of IEC 60079 specifies the general requirements for construction, testing and marking of Ex Equipment and Ex Components intended for use in explosive atmospheres. The standard atmospheric conditions (relating to the...

Note: This notice of intent was withdrawn by the responsible SDO on March 5, 2024, and is being replaced by ICC's NOI for CAN-ASC-2.5/ICC A118: Acoustics in the Built Environment (https://www.scc.ca/en/standards/notices-of...

1.1 This Standard applies to newly produced non-metallic dip tubes intended for use in water heaters. 1.2 Compliance of a dip tube with this Standard does not imply that such dip tube is acceptable for use in water heaters...

Standardization in the field of electromagnetic compatibility (EMC) including: Protection of radio reception in the range 9 kHz to 400 GHz from interference caused by operation of electrical or electronic appliances and...