Search

1.1 This method describes a procedure developed for colour matching of textiles. 1.2 Three different types of light sources are provided. These are intended to simulate north-sky daylight, incandescent lighting and commercial...

Please note the following NOI has been withdrawn on 2019-02-12 as requested by the responsible SDO. This method describes a procedure developed for colour matching of textiles. Three different types of light sources are...

1.1 This test method determines the wind uplift resistance of membrane-roofing systems when subjected to dynamic wind load cycles. The test methods are applicable to a) mechanically attached membrane roofing systems; and b)...

This test method describes the procedure used to quantify corrosion inhibitor (CI) additive containing di-linoleic acid (sold commercially as DCI-4A) in CGSB-3.24 aviation turbine fuel (ATF) military grade F-34 sample using...

1.1 The purpose of this test method is to investigate the ability of mattresses to resist rapid heat release by measuring specific fire test responses when the mattress or mattress set is subjected to a specified flaming...

This part of the lEC 60320 sets the dimensions for appliance couplers for two poles and two poles with earth contact – for the connection of electrical devices for household and similar onto the mains supply and – for the...

This technical report provides an introduction to the set of International Standards which describe local area networks, specifically those which make use of the 48-bit MAC address format. The MAC technologies described in...

1.1 These requirements apply to single and multiple jacketed lined fire hose of the following nominal inside diameter trade sizes: 38, 45, 50, 65, 77, 89, 100, 125 and 150 mm (1-1/2, 1-3/4, 2, 2-1/2, 3, 3-1/2, 4, 5, and 6...

This part of the lEC 60320 sets the dimensions for appliance couplers for two poles and two poles with earth contact – for the connection of electrical devices for household and similar onto the mains supply and – for the...

1 Scope 1.1 This document specifies the physical property requirements and test methods used to verify compliance of those material properties for low pressure spray applied rigid two-component polyurethane foam for use as...

Defines terms in the field of the sterilization of health care products including related equipment and processes.